1. 

   • 
   • 

   General

   The SP08 fire control and indicator panel is intended for marine use and completes with integral power changeover unit and standby power supply designed with its ancillary units to meet marine equipments.
   The high degree of component reliability and uncomplicated circuit design employed in this unit combine to produce an extremely low failure rate in service.

   Features

2. 1. Up to eight detection zones.
3. 2. Two wire detector circuits.
4. 3. Smoke, heat, flame and manual Call-points may be mixed on the same circuit.
5. 4. Fault monitoring of detector circuits, alarm sounder wiring, power supply and ground.
6. 5. Alarm output signal can be delayed up to 64 seconds.
7. 6. Detector circuits can be put into isolation mode up to 64 minutes.
8. 7. Self test function of fault and alarm conditions.
9. 8. Internal emergency battery provided.

1. Technical Specification

The control panel is normally mounted onto a bulkhead mounting type is available.

Features

1. 1. Up to sixteen detection zones.
2. 2. Two wire detector circuits.
3. 3. Smoke, heat, flame and manual Call-points may be mixed on the same circuit.
4. 4. Fault monitoring of detector circuits, alarm sounder wiring, power supply and ground.
5. 5. Alarm output signal can be delayed up to 64 seconds.
6. 6. Detector circuits can be put into isolation mode up to 64 minutes.
7. 7. Self test function of fault and alarm conditions.
8. 8. Internal emergency battery provided.

Technical Specification

The control panel is normally mounted onto a bulkhead mounting type is available.