- Strong POWER
As a 1W class SMD Type UV Power LED is built-in, drying speed is very quick, and time saving and work efficiency improved
- Quick drying (hardening) ability: GEL drying within 30~45 seconds
- ES-50 (3 pieces of 1W POWER LED, 4W) : Drying for both the Base and manicure is possible within 30, 45 seconds respectively.
Base & Top Gel : 30 sec / Color Gel : 45 sec
*Existing product: Mostly less than 4W
- Environment-friendly UV LED safe to the skin and proved was applied
- Enfren GEL Dryer applied the SMD type UV Power LED of 405nm frequency
: Since the UV-A (320-400nm), UV-B (290-320nm) emitted from the existing UV fluorescent are not discharged, it is safe to the skin
1. Eco-friendly LED lighting
: LED is eco-friendly as it does not use heavy metal such as mercury etc unlike the fluorescent
2. Drying is fast and strong as a light efficiency is high.
: Light efficiency is 3~5 times higher compared to the UV fluorescent
3. Many long hours use is possible as its life span is long
: Since the LED life span is about 50,000 hours, it is possible to use 6~8 times as long as the
4. Irradiating range is wider with the light dispersion angle against the existing lamp type LED.
: The lamp type is about 60°, but the SMD type is over 2 times wider with maximum 144°
5. Inferiority is few and safety is high by the use of small number of LEDs.
As it use only minimum 1/5~maximum 1/10 level compared to the lamp type, inferiority is low and
cost loss caused by replacement is small.
A system that once the hand is naturally put at the product’s lower part, it automatically recognize
and move was embodied (automatic recognition – movement – completion)
- As it equipped with a static capacity method touch sensor that moves after sensing the electric
current running in a man’s body, it is possible to use without wrong functioning from static
electricity or outside influence irrespective of day & night.
- It is normally operating even if it is stained with manicure, foreign substance etc or contaminated
- As a Timer is built-in, it automatically close after operating.
- Aluminum material LED PCB applied : LED life span improvement and reliability improvement
on account of the aluminum PCB use of superior heat protection structure.
- Use of the exclusive LED Driver IC : Product’s safety improvement through static current supply.
- LED position is adjusted different to each other considering the user’s convenience, position
and angle of the thumb : thumb LED is arranged at a right angle (90°) to left & right respectively
- Stand-by/movement: Indication LED is arranged on the product’s upper part
The person in chargeSeog Jin Kim
Address397 Suckeonro, Ojeong-Gu, Bucheon-Si, Gyeongi-Do,Korea (14449)
0 / 4000
At least 10~1000 characters.