DY-5000 Automatic Injector / Packer

The automatic motorized injector is specially designed for urethane stop-water injection, epoxy injection and reinforcement. It is well injected and easy to carry so that it will improve the efficiency of work

Uses
- Epocy Injection
- Urethane water-stop Injection
- Injection for iron plate, cracking and reinforcement, etc.

Specification
- Power : 220V/60Hz (Single phase)
- Max. pressure : 380~700kgf/cm2
- Flow-rate : 1st level 0.7~0.8l/min, 2nd level 1.2~1.5l/min
- Weight : 7kg

How to use
- Tightne cylinder, hose, and nozzle using a wrench befoe first use
- Cut off the lowder part of an 1.5 plastic bottle and fix its mouth to the epoxy inlet (No.11 rubber ring) and then fill the injector up to 2/3 level with hydraulic oil
- Connect the power plug to 220V single-phase power source, set the control switch to level 2 and press the pushbutton to start operation
- Put the desired chemical in the bottle when the hydraulic oil goes out of the nozzle and set the control switch to level 1 after the chemical starts going out from the inlet
- It is desirable to inject at Level 1. If the hydraulic hose expands during injection, stop injecting and cover the inlets with a piece of cloth or a rag to prevent the chemical from spattering. Then shake the nozzle from side to take it out and keep working on another inlets

- The actual amount required may very with the site conditions
- Please work after make sure for mixing ratio for sure