VitaOxy 510 Oxygen Concentrator
• Applicable to both invasive (tracheostomy) and non-invasive (mask) patients in hospitals or at home.
• Various patient-friendly alarm modules innate.
Liter Flow |
1 ~ 5 LPM |
Oxygen Concentration |
93 +/- 3% |
Sound level |
less than 45 dB |
Power |
220V, 60 HZ, 290 W |
Dimensions |
390 x 230 x 600 mm |
Weight |
14.2 kg |
Advantages
1. Quality Quaranteed with ISO13485, KGMP, and FDA 510k pending
2. Low noise level optimized for daily usage
3. Consistent oxygen flow even in warm and humid weather
How to Use
1) Take the humidifier and cannula from the product package.
2) Turn the humidifying bottle counterclockwise and remove the cap. Add distilled water up to the indicated portion. Fill it and close the cap.
※ Distilled water or cooled boiled water must be used in the humidifying bottle.
3) To check whether the humidifier cap and bottle are well connected, press the humidifier outlet for 20 seconds.
Block with your index finger and if the black ball inside the flowmeter falls to the floor, release your hand.
Make sure you hear a “chu” sound. If you hear a sound, the humidifier cap and bottle are properly connected.
4) If there is no sound, it means there is a leak.
Insert the humidifier filled with liquid water into the humidifier socket of the main body.
Secure it with the attached band.
5) Connect to the oxygen outlet of the main body and the humidifier.
Connect the two by inserting a tube into each.
6) Connect the power, turn on the switch on the main unit, and adjust the flowmeter so that the ball of the flowmeter floats.
7) When power is supplied, the green “Power” light turns on and a “beep beep” warning sound sounds.
8) About 6 minutes after the warning sound sounds, oxygen at the standard concentration is supplied from the discharge port.
9) To adjust the desired flow rate, position the ball at the corresponding flow mark on the flowmeter.
Rotate the knob of flowmeter.
※ When the knob of flowmeter is rotated clockwise, the flow rate decreases and when the knob of flowmeter is rotated counterclockwise.
If you do this, wandering will increase.
※ For health care, the flow rate is 1-2L/min and the daily oxygen intake time is 45-60 minutes.
do. (Prescription by a specialist according to the patient is given priority.)
※ The ball should not be raised above the red line of the flowmeter. If the ball rises above the red line, the flow may be reduced.
10) Insert the intake part of the oxygen tube into the outlet part of the humidifier, and insert the nasal cannula on the patient's ear.
11) Insert the nasal tube into the patient’s nostrils and start oxygen treatment (oxygen supply).
12) If a longer tube is needed, connect the extension tube to the outlet of the humidifier.
13) When treatment is finished, turn off the power switch of the product body.
Company Overview
Chosun Instrument Inc. is a legacy company with over 45 years of expertise in medical gas & medical devices. With a cumulative installation site of over 110 major hospitals in S. Korea, Chosun Instrument leads the Korean medical gas engineering industry. Chosun Instrument also produces its own line of Oxygen Concentrators, supplying medical-grade oxygen at home and healthcare facilities.
In 2018, Chosun Instrument acquired Vikomed, an X-Ray manufacturer in Vietnam to expand its business to Diagnostic Radiography. In 2023, Chosun Instrument acquired Mfours, an X-Ray manufacturer in S. Korea to expand its X-Ray portfolio by adding not only X-Ray, but also C-Arm, Mammographic System, Flat Panel Detector, Viewer & PACS Software.
Chosun Instrument's quality is certified with ISO13485, ISO9001, and KGMP.
Other Products